Masonry Drill Bits: Difference between revisions
m (photo coming soon) |
(available sizes, added photo) |
||
| Line 19: | Line 19: | ||
{{ToolInfoBox | {{ToolInfoBox | ||
|tool name=SDS Bits | |tool name=SDS Bits | ||
|image= | |image=SDS bits.JPG | ||
|synonyms=SDS shank bits, SDS drill bits, SDS chisel bits;<br>DE: SDS-Bohrer, SDS-Meißel | |synonyms=SDS shank bits, SDS drill bits, SDS chisel bits;<br>DE: SDS-Bohrer, SDS-Meißel | ||
|type=[[bits]] | |type=[[bits]] | ||
| Line 31: | Line 31: | ||
Our [[Rotary Hammer|rotary hammer]] has a chuck for "SDS-plus" drill bits or chisels. | Our [[Rotary Hammer|rotary hammer]] has a chuck for "SDS-plus" drill bits or chisels. | ||
=== Selection === | |||
We currently have the following SDS drill bits: | |||
* 5 mm, ''short'' | |||
* 6 mm, ''short'' | |||
* 8 mm, ''short'' | |||
* 6 mm, ''long'' | |||
* 8 mm, ''long'' | |||
* 10 mm, ''long'' | |||
* 12 mm, ''long'' | |||
In addition, we have three 250 mm chisel bits with a pointed tip, a 20 mm wide tip and a 40 mm wide tip. | |||
[[Category:Bits]] | [[Category:Bits]] | ||
Revision as of 12:23, 17 April 2018
| ToolInfoBox Masonry Drill Bits | |
|---|---|
| |
| Synonyms: | DE: Steinbohrer |
| Type: | bits |
| Material: | stone, concrete |
| Used with: | impact drill (shop vac to clean up) |
| Location: | drilling table |
| Access Requirements: | upon reading |
Masonry drill bits are not very sharp but possess a hard carbide chisel tip - therefore you need a impact drill or a more powerful rotary hammer to be successful in most cases.
Once you're done drilling (make sure to wear personal protection against dust and stone chips!), you'll usually need wall anchors to secure anything in the hard substrate.
We can't just let everyone drill into the walls, but please don't hesitate to tell a manager if there is a spot that could really use a hole!
SDS Bits
| ToolInfoBox SDS Bits | |
|---|---|
| |
| Synonyms: | SDS shank bits, SDS drill bits, SDS chisel bits; DE: SDS-Bohrer, SDS-Meißel |
| Type: | bits |
| Material: | stone, concrete |
| Used with: | rotary hammer (shop vac to clean up) |
| Location: | drilling table |
| Access Requirements: | upon reading |
These special bits are not compatible with regular jawed drill chucks! They have grooves which allow them to move back and forth within an SDS chuck.
Our rotary hammer has a chuck for "SDS-plus" drill bits or chisels.
Selection
We currently have the following SDS drill bits:
- 5 mm, short
- 6 mm, short
- 8 mm, short
- 6 mm, long
- 8 mm, long
- 10 mm, long
- 12 mm, long
In addition, we have three 250 mm chisel bits with a pointed tip, a 20 mm wide tip and a 40 mm wide tip.
