Sewing Machine Introduction: Difference between revisions
From CoMakingSpace Wiki
(→Demonstration: dust cover) |
(tutor Anita) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
This is the content required for an introduction to our [[Introduction for::Sewing Machine|sewing machine]] - '''reading this does NOT replace the mandatory session with a [[tutor]]!''' It will make it a lot quicker though ;-) | This is the content required for an introduction to our [[Introduction for::Sewing Machine|sewing machine]] - '''reading this does NOT replace the mandatory session with a [[tutor]]!''' It will make it a lot quicker though ;-) | ||
If you need this introduction, please reach out to the following tutors: [[Tutor::User:Utis|Utis]] | If you need this introduction, please reach out to the following tutors: [[Tutor::User:Utis|Utis]], [[Tutor::User:Anitamareike|Anita]] | ||
Let's begin! First off, make sure you have read the machine's [https://manuall.de/necchi-559-nahmaschine/ manual]. | Let's begin! First off, make sure you have read the machine's [https://manuall.de/necchi-559-nahmaschine/ manual]. | ||
| Line 36: | Line 36: | ||
* cleaning up for the day | * cleaning up for the day | ||
** | ** turn off the machine and store the foot pedal in one of the boxes on the table | ||
** get rid of lint ''(Fussel)'' on the transporting teeth (manual: page 46) by brushing them off, NOT blowing them deeper into the machine | ** get rid of lint ''(Fussel)'' on the transporting teeth (manual: page 46) by brushing them off, NOT blowing them deeper into the machine | ||
** do the same for the inside of the bobbin case (manual: page 45); may easily be combined with oiling this part | ** do the same for the inside of the bobbin case (manual: page 45); may easily be combined with oiling this part | ||
Latest revision as of 21:39, 20 October 2023
This is the content required for an introduction to our sewing machine - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)
If you need this introduction, please reach out to the following tutors: Utis, Anita
Let's begin! First off, make sure you have read the machine's manual.
Safety
| Dangers | Precaution |
|---|---|
 |
DO NOT put your fingers under the needle while working with the machine - use the presser foot as a minimum distance guide |
 |
ensure the machine is turned off and disconnected from power when changing the needle, thread, or accessing any of the inner parts |
 |
DO NOT touch the lamp after the sewing machine has run for a while |
Demonstration
The tutor will show you these steps in detail:
- where to oil the machine regularly (manual: pages 45-48)
- thread the yarn both from the bottom and the top of the machine
- spool your choice of thread onto a bobbin (Unterfadenspule)
- free up the thread in case it gets tangled up
- change the needle
- change the presser foot
- change the sewing direction
- change the seam pattern - always lift the needle before changing anything, otherwise a sideways adjustment may break the needle!
- operate the machine
- at this point, you will create a trial seam
- cleaning up for the day
- turn off the machine and store the foot pedal in one of the boxes on the table
- get rid of lint (Fussel) on the transporting teeth (manual: page 46) by brushing them off, NOT blowing them deeper into the machine
- do the same for the inside of the bobbin case (manual: page 45); may easily be combined with oiling this part
- put a piece of scrap fabric on the needle plate, lower the needle and put down the pressure foot
- last but not least put the dust cover back over the machine!
