Sewing Machine Introduction: Difference between revisions
From CoMakingSpace Wiki
(added intro section, danger icons, category; removed "incomplete" notice) |
(→Demonstration: added cleanup steps (from Category:Sewing)) |
||
| Line 22: | Line 22: | ||
The tutor will show you these steps in detail: | The tutor will show you these steps in detail: | ||
*where to oil the machine regularly ([https://manuall.de/necchi-559-nahmaschine/ manual]: pages 45-48) | |||
*thread the yarn both from the bottom and the top of the machine | *thread the yarn both from the bottom and the top of the machine | ||
*spool your choice of thread onto a bobbin ''(Unterfadenspule)'' | *spool your choice of thread onto a bobbin ''(Unterfadenspule)'' | ||
| Line 29: | Line 30: | ||
*change the sewing direction | *change the sewing direction | ||
*operate the machine | *operate the machine | ||
** at this point, you will create a '''trial seam''' | |||
* cleaning up for the day | |||
** take out the bobbin of the lower thread | |||
** get rid of lint ''(Fussel)'' on the transporting teeth (manual: page 46) by brushing them off, NOT blowing them deeper into the machine | |||
** do the same for the inside of the bobbin case (manual: page 45); may easily be combined with oiling this part | |||
** last but not least put a piece of scrap fabric on the needle plate, lower the needle and put down the pressure foot | |||
Revision as of 21:24, 20 July 2021
This is the content required for an introduction to our sewing machine - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)
Let's begin! First off, make sure you have read the machine's manual.
Safety
| Dangers | Precaution |
|---|---|
 |
DO NOT put your fingers under the needle while working with the machine - use the presser foot as a minimum distance guide |
 |
ensure the machine is turned off and disconnected from power when changing the needle, thread, or accessing any of the inner parts |
 |
DO NOT touch the lamp after the sewing machine has run for a while |
Demonstration
The tutor will show you these steps in detail:
- where to oil the machine regularly (manual: pages 45-48)
- thread the yarn both from the bottom and the top of the machine
- spool your choice of thread onto a bobbin (Unterfadenspule)
- free up the thread in case it gets tangled up
- change the needle
- change the presser foot
- change the sewing direction
- operate the machine
- at this point, you will create a trial seam
- cleaning up for the day
- take out the bobbin of the lower thread
- get rid of lint (Fussel) on the transporting teeth (manual: page 46) by brushing them off, NOT blowing them deeper into the machine
- do the same for the inside of the bobbin case (manual: page 45); may easily be combined with oiling this part
- last but not least put a piece of scrap fabric on the needle plate, lower the needle and put down the pressure foot
