Router Table Introduction

The handheld router introduction is required as a background for this introduction!

When working on a router table, additional care needs to be taken as the router is turned upside down in a fixed position!

proper feed directions for safe push cuts - click to see an animation!

• the workpiece can be grabbed and shot across the room if you attempt a climb cut, only do push cuts!
  • only feed from right to left when you work in front of the bit!
  • see schematic for other cases, but make sure you really understand what's going on
• make sure the router table is screwed or clamped to a workbench before turning it on
• keep all body parts at least a hand's width away from the exposed bit (use push blocks if that's not possible)
• use all possible fences, guards, featherboards etc. to secure the workpiece and reduce exposure of the bit
• make use of a starting pin (or similar) when working fenceless with a bearing bit ^{tip #6}