Oscillating Tool Introduction
From CoMakingSpace Wiki
This page is INCOMPLETE and still missing some important information before it can be used as a resource. Please use the "Discussion" feature above or talk to one of the tutors if you would like to help improve it. Thanks!
This is the content required for an introduction to our Oscillating Tool - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)
Let's begin! First off, make sure you have read the machine's manual (for a link please see the tools page).
Safety
Dangers
An oscillating tool is basically a fast moving tool with different attachments, which can be Saws, Sandpaper or other attachments. Therefore, similar dangers exists:
- sawdust and small splinters can fly towards the operator and others
- When cutting into metal, sparks can be generated and fly towards the operator
- medium amount of noise, but close to the operator's head
- no prevention of turning on after loss & restoration of power (keine Anlaufsicherung)
Precautions
- wear goggles to protect your eyes from sparks, splinters and other things flying around
- wear ear defenders
- wear gloves
- ensure the attachment you are using is proper for the material you are cutting into
- ensure the material is well attached to a solid surface
- if the power has been lost for whatever reason, always switch the power switch to "OFF" before restoring it!
Demonstration
The tutor will show you these steps in detail:
- How to operate the oscillating tool
- How to change the attachment
