Horizontal Bandsaw: Difference between revisions
From CoMakingSpace Wiki
(do-something #284) |
(needs guide bearings) |
||
| Line 21: | Line 21: | ||
|SecurityComment= | |SecurityComment= | ||
|Test= | |Test= | ||
|TestComment= | |TestComment=known problem: needs new guide bearings (4x, type: ??) | ||
|OwnerValue= | |OwnerValue= | ||
|OwnerValueComment=donation from [[Mamad]] | |OwnerValueComment=donation from [[Mamad]] | ||
Revision as of 15:46, 28 January 2023
A horizontal bandsaw is like a chop saw for metalworking: it can nicely cut a straight piece of stock into smaller bits at the angle you desire!
Further reading:
This tool is not ready for use yet since not all commissioning steps have been completed. The process is also tracked on GitHub. Feel free to contribute to making it usable, any help is very welcome!
| Task | comment | Status |
|---|---|---|
| Name the tool: | very similar newer model: Herkules HMB 4000 | Herkules ..... |
| Take a picture | - | pending |
| Find the manual as PDF | probably similar enough: Herkules HMB 4000 (manualslib) | pending |
| Documentation | this page, status: in commissioning | pending |
| Print QR-Code | use the wikicrawler | pending |
| Introduction | may need a separate intro from our vertical bandsaws - let's start by collecting everything here & see clear later | pending |
| Security Check | to be done or witnessed by a manager | pending |
| Test | known problem: needs new guide bearings (4x, type: ??) | pending |
| tool's name, owner and approx. value | donation from Mamad | pending |
| Last step: make it available | physically and in the wiki - then delete this template | pending |
