Router Table Introduction
From CoMakingSpace Wiki
The handheld router introduction is required as a background for this introduction!
If you received that introduction before 2020-4-15, it still included the router table part and you only need to make sure you now watch both pages for updates. And as always: feel free to ask for a refresher whenever anything is not clear anymore!
When working on a router table, additional care needs to be taken as the router is turned upside down in a fixed position!
- the workpiece can be grabbed and shot across the room if you attempt a climb cut, only do push cuts!
- only feed from right to left when you work in front of the bit!
- see schematic for other cases, but make sure you really understand what's going on
- make sure the router table is screwed or clamped to a workbench before turning it on
- keep all body parts at least a hand's width away from the exposed bit (use push blocks if that's not possible)
- use all possible fences, guards, featherboards etc. to secure the workpiece and reduce exposure of the bit
- make use of a starting pin (or similar) when working fenceless with a bearing bit tip #6
Demonstration
The Tutor will show you in detail how to
- Adjust and lock the height of the router
- Insert the bit into the router
- Tighten the collet
- Turn the router on and off by using the safety switch of the router table
