Fusion 360 CAM Parameters

The CAM parameters in Fusion 360 (or other CAM programs, but they might differ) are restricted in many ways. Here we list the limitations we know of:

Heights

Sicherheitshöhe - height at which the router can travel at full speed
- should definitely be far enough away from the workpiece and any holddowns you might be using
Rückzugshöhe - height at which the router can travel between operations (without crashing into screws or uneven areas)
- above the workpiece, but not necessarily above all elements on the table
- should be equal or higher than the Vorschubhöhe
Vorschubhöhe - height at which the router starts traveling at your specified feedrate
- below this height, the workpiece is expected to start
obere Höhe - final height of your finished object
- usually set automatically
Endhöhe - maximum depth you want to reach
- 0 should be the bottom of your workpiece = the surface of the spoilboard
- go a little bit into the negative numbers (e.g. -0.5 mm) to make sure a cut goes through

If you think you've got it right and the software does not give you warnings anymore, still make sure to watch the simulation and pay attention to any possible problems!

Feedrates

Always make sure the different feedrates are suited to your current cutter!

Schnittvorschub
Einfahrvorschub
Eintauchvorschub
Ausfahrvorschub
Helixvorschub

Cut Depths

Maximale Schrupp-Tiefenzustellung
Feintiefenzustellung

Postprocessing

Once you're happy, here's how to export your work:

select all operations you want to export as G-Code
Aktionen -> Postprozess -> Postprozessor-Konfiguration "Grbl/grbl" -> Postprozessor -> save under desired title
- disable the option "G28 Safe retracts" - it's not supported by grbl!