Talk:Router Table

Feed Direction

My "only feed left to right" comment applies only to the (very common) setup with a fence and working on the outside of a workpiece, not to inside cuts - same as with the "different" proper feed directions for inside and outside cuts with a handheld router. We should probably illustrate this with a schematic rather than an easily misunderstood sentence... --Lukas (talk) 17:31, 20 September 2018 (CEST)

Schematic is schematized! Even with animation as this is really important... Any remaining questions? --Lukas (talk) 17:41, 23 October 2018 (CEST)

yes, two points:

1. The animation does only show when you specifically open the gif due to the high resolution. Does it really need to be a high resolution gif?

2. The animation only shows cutting on the inside of your workpiece. I understand that the principle is the same when cutting on the outside. However, I would propose a specific schematic for that. --NitramLegov (talk) 20:41, 23 October 2018 (CEST)

I'd say the animation is a bonus, I just had some time to kill and that's what came out...but I am planning to draw another schematic with a fence installed. Maybe the GIF can still be compressed (if a constant loop on the page is desirable)? --Lukas (talk) 22:20, 23 October 2018 (CEST)