Archived:Hot Air Introduction
From CoMakingSpace Wiki
This is the content required for an introduction to our heat gun and hot air soldering station - reading this does NOT replace the mandatory session with a tutor! It will make it even quicker though ;-)
Let's begin! First off, make sure you have read the tool's manual, if available.
Safety
Dangers
- very hot air is produced (over 500 °C)
- the nozzle stays hot for a while after turning off
- toxic fumes can be generated when heating certain materials
- no prevention of turning on after loss & restoration of power (keine Anlaufsicherung)
Precautions
- don't point the nozzle at body parts or other people
- use a well-insulated glove if you have to hold the workpiece in your hand
- take care of good ventilation and don't inhale the fumes
- get familiar with the type of solder you're using or the kind of paint you're removing - for instance, does it contain poisonous lead?
- allow time for the nozzle to cool down before touching it or placing the tool into its case
- make sure the surface you put your workpiece on can handle the hot air
- if the power has been lost for whatever reason, always turn the button to "0" before restoring it!
