Oscillating Tool Introduction: Difference between revisions
From CoMakingSpace Wiki
m (removed "incomplete" note) |
NitramLegov (talk | contribs) (added dust mask, added showing the shop vac, put in a comment about Starlock.) |
||
Line 17: | Line 17: | ||
* wear [[ear defenders]] | * wear [[ear defenders]] | ||
* wear [[gloves]] | * wear [[gloves]] | ||
* dependent on your workpiece and action: wear a [[Dust Mask|dust mask]]. This is especially important when using the sanding attachment. | |||
* ensure you are using the proper attachment for the material you are working with | * ensure you are using the proper attachment for the material you are working with | ||
* ensure the attachment is securely connected to the tool's head | * ensure the attachment is securely connected to the tool's head | ||
Line 26: | Line 27: | ||
The tutor will show you these steps in detail: | The tutor will show you these steps in detail: | ||
* how to operate the oscillating tool | * how to operate the oscillating tool | ||
* how to change the attachment ("Starlock" system | * how to attach the shop vac adapter | ||
* how to change the attachment (adapter + screws, "Starlock" system not available currently) | |||
[[Category:Introductions]] | [[Category:Introductions]] |
Revision as of 09:26, 18 October 2018
This is the content required for an introduction to our oscillating tool - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)
Let's begin! First off, make sure you have read the machine's manual.
Safety
Dangers
An oscillating tool is basically a fast moving tool with different attachments for cutting, rasping or sanding. Therefore, similar dangers as with power saws or sanders exist:
- sawdust and small splinters can fly towards the operator and others
- when cutting into metal, sparks can be generated and fly towards the operator
- medium amount of noise, but close to the operator's head
- no prevention of turning on after loss & restoration of power (keine Anlaufsicherung)
- attachments might bind with the material if used too forcefully, causing excessive wear of the attachments and vibrations in the handle
Precautions
- wear goggles to protect your eyes from sparks, splinters and other things flying around
- wear ear defenders
- wear gloves
- dependent on your workpiece and action: wear a dust mask. This is especially important when using the sanding attachment.
- ensure you are using the proper attachment for the material you are working with
- ensure the attachment is securely connected to the tool's head
- ensure the material is well attached to a solid surface
- if the power has been lost for whatever reason, always switch the power switch to "OFF" before restoring it!
- use only very little pressure and let the rapid oscillation do the work!
Demonstration
The tutor will show you these steps in detail:
- how to operate the oscillating tool
- how to attach the shop vac adapter
- how to change the attachment (adapter + screws, "Starlock" system not available currently)