Handheld Router Introduction

This is the content required for an introduction to our Router - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)

Safety

Dangers

• exposed & rapidly spinning router bit
• no prevention of turning on after loss & restoration of power (keine Anlaufsicherung)
• The drill gets extremely hot. Therefore, the sawdust can take fire.

Precautions

• wear personal protection but not gloves, they could get caught!
  • goggles for sure, a dust mask could be necessary depending on your material
• stay clear of the bit when in operation (both hands on the handles!)
• unplug the router when changing a bit or touching the collet for any other reason
• be prepared for sudden movements of the workpiece and make sure it is properly secured
  • small workpieces (smaller than half the tool's base in width OR length) are not suitable for the router until we build a router table
• always check whether the tool movement you are planning is possible before turning it on - adjust depth if necessary
• make sure there is nobody nearby who might be surprised by a piece of shrapnel flying their way!
• if the power has been lost for whatever reason, make sure the router is turned off before restoring it!

Hints

• be cautions not to remove too much material at a time

Suggested Readings

For Tips and Tricks read the book "Woodworking with the Router" (available at the space). Tips for choosing the proper feed direction can be found on page 37ff.