Archived:Hot Air Introduction: Difference between revisions
From CoMakingSpace Wiki
(manuals not linked on tool pages yet) |
No edit summary |
||
| Line 7: | Line 7: | ||
* very hot air is produced (over 500 °C) | * very hot air is produced (over 500 °C) | ||
* the nozzle stays hot for a while after turning off | * the nozzle stays hot for a while after turning off | ||
* | * toxic fumes can be generated when heating certain materials | ||
=== Precautions === | === Precautions === | ||
| Line 15: | Line 15: | ||
* get familiar with the type of [[solder]] you're using or the kind of paint you're removing - for instance, does it contain poisonous lead? | * get familiar with the type of [[solder]] you're using or the kind of paint you're removing - for instance, does it contain poisonous lead? | ||
* allow time for the nozzle to cool down before touching it or placing the tool into its case | * allow time for the nozzle to cool down before touching it or placing the tool into its case | ||
* make sure the surface you put your workpiece on can handle the hot air | |||
[[Category:Introductions]] | [[Category:Introductions]] | ||
Revision as of 18:53, 3 May 2018
This is the content required for an introduction to our heat gun and hot air soldering station - reading this does NOT replace the mandatory session with a tutor! It will make it even quicker though ;-)
Let's begin! First off, make sure you have read the tool's manual, if available.
Safety
Dangers
- very hot air is produced (over 500 °C)
- the nozzle stays hot for a while after turning off
- toxic fumes can be generated when heating certain materials
Precautions
- don't point the nozzle at body parts or other people
- use a well-insulated glove if you have to hold the workpiece in your hand
- take care of good ventilation and don't inhale the fumes
- get familiar with the type of solder you're using or the kind of paint you're removing - for instance, does it contain poisonous lead?
- allow time for the nozzle to cool down before touching it or placing the tool into its case
- make sure the surface you put your workpiece on can handle the hot air
