Project:Patricks Locker: Difference between revisions
From CoMakingSpace Wiki
(Created page with "{{ProjectInfoBox |project title=Patricks Lockers |image=Patricks Locker current.jpg |status=pretty much done |date=Early 2018 |initiator={{P}} |team= |materials=Some scrap woo...") |
m (linked lockers & table saw, hope that's right ;-)) |
||
| Line 1: | Line 1: | ||
{{ProjectInfoBox | {{ProjectInfoBox | ||
|project title= | |project title=Patrick's Locker | ||
|image=Patricks Locker current.jpg | |image=Patricks Locker current.jpg | ||
|status=pretty much done | |status=pretty much done | ||
| Line 12: | Line 12: | ||
}} | }} | ||
Our [[lockers]] are quite spacious, but for smaller parts they need individual storage. | |||
== Divider == | == Divider == | ||
The divider in the middle was cut on the [[ | The divider in the middle was cut on the [[Table Saw|table saw]] and the two pieces were screwed together. It is secured by a single bracket on the left side to the locker wall. The space on the lower left is sized to fit a sorting box from Aldi to store smaller parts. | ||
<gallery> | <gallery> | ||
Latest revision as of 08:03, 27 September 2018
| ProjectInfoBox Patrick's Locker | |
|---|---|
| |
| Status: | pretty much done |
| Release Date: | Early 2018 |
| Initiator: | Patrick |
| Materials Used: | Some scrap wood from the Project:Lockers |
Our lockers are quite spacious, but for smaller parts they need individual storage.
Divider
The divider in the middle was cut on the table saw and the two pieces were screwed together. It is secured by a single bracket on the left side to the locker wall. The space on the lower left is sized to fit a sorting box from Aldi to store smaller parts.
First measurements.
First fitting.
Cutting in a slot to be able to reach the handle of the box.
Done.
Door
- Storage cabinet (from ALDI, thanks Ciaran!)
- 3D printed knipex holder
- 3D printed hex key holder
- 3D printed googles holder
- 3D printed Nerf holder...
