Oscillating Tool Introduction

This is the content required for an introduction to our oscillating tool - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)

Let's begin! First off, make sure you have read the machine's manual.

Safety

Dangers

An oscillating tool is basically a fast moving tool with different attachments for cutting, rasping or sanding. Therefore, similar dangers as with power saws or sanders exist:

• sawdust and small splinters can fly towards the operator and others
• when cutting into metal, sparks can be generated and fly towards the operator
• medium amount of noise, but close to the operator's head
• no prevention of turning on after loss & restoration of power (keine Anlaufsicherung)
• attachments might bind with the material if used too forcefully, causing excessive wear of the attachments and vibrations in the handle

Precautions

• wear goggles to protect your eyes from sparks, splinters and other things flying around
• wear ear defenders
• wear gloves
• dependent on your workpiece and action: wear a dust mask. This is especially important when using the sanding attachment.
• ensure you are using the proper attachment for the material you are working with
• ensure the attachment is securely connected to the tool's head
• ensure the material is well attached to a solid surface
• if the power has been lost for whatever reason, always switch the power switch to "OFF" before restoring it!
• use only very little pressure and let the rapid oscillation do the work!

Demonstration

The tutor will show you these steps in detail:

• how to operate the oscillating tool
• how to attach the shop vac adapter
• how to change the attachment (adapter + screws, "Starlock" system not available currently)