Soldering Iron Introduction: Difference between revisions
From CoMakingSpace Wiki
m (→Precautions: linked goggles) |
(master/slave setup) |
||
| Line 16: | Line 16: | ||
* get familiar with the type of [[solder]] you're using - for instance, does it contain poisonous lead? | * get familiar with the type of [[solder]] you're using - for instance, does it contain poisonous lead? | ||
* wash your hands after handling solder | * wash your hands after handling solder | ||
== Demonstration == | |||
Our electronics bench is set up in a master/slave fashion to reduce the risk of accidentally leaving soldering irons on over night - the black outlet bar only works when the desk lamp is on. | |||
[[Category:Introductions]] | [[Category:Introductions]] | ||
Revision as of 20:25, 19 September 2018
This is the content required for an introduction to our soldering irons - reading this does NOT replace the mandatory session with a tutor! It will make it even quicker though ;-)
Let's begin! First off, make sure you have read the tool's manual, if available.
Safety
Dangers
- the tip gets very hot (over 300 °C)
- toxic fumes are be generated when soldering or overheating neighboring components
- hot flux can squirt towards you during soldering
- the solder may contain poisonous lead
Precautions
- only touch the handle, rest the iron in its stand when not using it
- take care of good ventilation and don't inhale the fumes, use a fume extractor with carbon filter
- protect your eyes with goggles
- get familiar with the type of solder you're using - for instance, does it contain poisonous lead?
- wash your hands after handling solder
Demonstration
Our electronics bench is set up in a master/slave fashion to reduce the risk of accidentally leaving soldering irons on over night - the black outlet bar only works when the desk lamp is on.
