PrusaLink

Our Prusa MK3 Printers (P9, P10, P11) are connected to a PrusaLink instance. You can use PrusaLink to start prints directly from the slicer or to upload gcode via the web interface. To do so, use the predefined printer (P9, P10, P11) in the OrcaSlicer on the computer in the Electronics Room or visit the web interface directly from the LAN at http://10.2.0.8:80. Or visit the interface for each printer directly:

• P9: http://10.2.0.8:8081
• P10: http://10.2.0.8:8082
• P11: http://10.2.0.8:8083

For all printers, the username is "prusa" and the password is "Prusa@CoMakingSpace".

You can also setup the printers directly in your own slicer (as long as it supports PrusaLink). If you want to use the API Key instead of the username and password, you can do so for each printer:

• P9: "8dRByx89lmceBg"
• P10: "v95JHWT-D2Ykaw"
• P11: "EOWEQ-EELaeCXw"

Note that sending the gcode normally works, but the Device tab often says "Unauthorized".