Handheld Sander Introduction

This is the content required for an introduction to our handheld sanders - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)

Let's begin! First off, make sure you have read the machine's manual (should be linked from its wiki page).

Safety

Personal protection:

ear defenders and gloves are also recommended when working with a sander (and shop vac) for an extended amount of time

Dangers	Precautions
lots of fine dust from wood or plastics - can irritate lungs and skin	wear a dust mask and long clothes if your material generates hazardous dust check for a clean run and fit of the sanding medium before you start; check if hole alignment for the dust extraction is correct sand outside if you can't connect a shop vac or fine filter do not blow the workpiece clean when you're done, best clean it with a moist towel
sparks from sanding metal	when sanding metal, do NOT connect dust collection - the sparks could cause a fire! wear goggles when working with metal
powerful movements can make the workpiece shift (or fly!) and let a handheld sander "run away"	wear goggles when working with small workpieces secure your workpiece and exert a firm grip on the tool let the tool get to full speed before contacting your workpiece and start with light pressure
some of the sanders have no prevention of turning on after loss & restoration of power (keine Anlaufsicherung)	make sure the tool is turned off before plugging it in

Protect the Velcro

WRONG!

Do NOT sand with parts of the velcro pad uncovered - this will wear it out and lead to much poorer bonding of the next piece of sandpaper!

Suggested Reading

Besides these safety notes, you should read the page about dust to get a better conception of the dangers associated with some materials! Remember, you are responsible for the material you choose and for protecting yourself.