Handheld Circular Saw Introduction

This is the content required for an introduction to our circular saws - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)

Let's begin! First off, make sure you have read the machine's manual:

Herkules BHK 1600LE "Laser Beam"
Festool TS 75 EBQ (plunge saw)

Safety

Dangers

sawdust and small splinters can fly towards the operator and others
sharp and rotating exposed blade - will keep spinning for a bit after turning the power off!
kickback: if the blade binds with the material it can push the saw back towards the user

Precautions

general:

hook up a shop vac, but be aware the dust extraction from our "Herkules" saw is very incomplete
wear goggles and ear defenders!
dust mask: depending on the material you're cutting
get a helper who can hold your cutoff (depending on the size it) so it doesn't fall down
make sure the cutting path is free of obstacles (except your workpiece of course)
let the saw start before touching the workpiece
keep the saw secure after your cut until is has come to a complete stop

plunge saw (Festool TS 75):

when doing a plunge cut make sure the rail/workpiece can't move sideways. This could cause the blade to bind and kickback.
- attach the endstop to the rail to reduce the chance of kickback
use an appropriately sized riving knife (DE: Spaltkeil) when using a different blade
- remove the riving knife for plunge cuts, otherwise it can get in the way

Demonstration

The tutor will show you these steps in detail:

using the proper circular saw guide

Festool TS 75:

change cutting angle
change and lock cutting depth