Talk:Router Table

Feed Direction

My "only feed left to right" comment applies only to the (very common) setup with a fence and working on the outside of a workpiece, not to inside cuts - same as with the "different" proper feed directions for inside and outside cuts with a handheld router. We should probably illustrate this with a schematic rather than an easily misunderstood sentence... --Lukas (talk) 17:31, 20 September 2018 (CEST)

Schematic is schematized! Even with animation as this is really important... Any remaining questions? --Lukas (talk) 17:41, 23 October 2018 (CEST)