Handheld Router Introduction

This is the content required for an introduction to our router - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)

First off, make sure you have read the tool's manual.

Safety

Dangers

exposed & rapidly spinning router bit
- will keep spinning for a few seconds after the tool is turned off
flying splinters and dust
no prevention of turning on after loss & restoration of power (keine Anlaufsicherung)
the bit gets extremely hot
- can potentially set the sawdust on fire
- remains hot for a while after using
the bit can bite into the workpiece and cause kickback if the wrong feed direction is applied

Precautions

wear personal protection but not gloves, they could get caught!
- goggles for sure, a dust mask could be necessary depending on your material
- ear defenders are also required
hook up a shop vac to extract (most of) the dust at the source
stay clear of the bit when in operation (both hands on the handles!)
unplug the router when changing a bit or touching the collet for any other reason
always keep at least one of the two columns over your workpiece, that way the base should be stable and won't tip over
do not let the bit touch the workpiece before it has reached its full speed
be prepared for sudden movements of the workpiece and make sure it is properly secured
- small workpieces (smaller than half the tool's base in width OR length) are not suitable for the router until we build a router table
always check whether the tool movement you are planning is possible before turning it on - adjust depth if necessary
make sure there is nobody nearby who might be surprised by a piece of shrapnel flying their way!
if the power has been lost for whatever reason, make sure the router is turned off before restoring it!

Feed Direction

The standard direction is the "push" cut, i.e. against the direction the bit would pull the router if you let go. In short, you need to move the router counter-clockwise around the outside of a workpiece and clockwise for inside work (holes, recesses). It is probably more clear after watching this video tutorial!

As mentioned in the video as well, there are only a few situations where you might want to try a "climb" cut once you are sufficiently experienced with this tool. When you do attempt climb cuts, be aware that it can cause kickback to the router and the workpiece! Only take shallow passes to maintain control.

Feedrate

The proper combination of rotation speed and tool advancement is determined by your bit and material.

be cautions not to remove too much material at a time - several passes are usually necessary if you want to go deep
going too slow can cause the wood to burn, going to fast can cause the wood to splinter and even damage the bit

Demonstration

The tutor will show you these steps in detail:

inserting a bit
- unplug the router
- choose the proper collet that matches the bit's shaft diameter (6 or 8 mm)
- insert at least 20 mm of the bit's shaft
- check proper fit and balance before turning the motor on