Handheld Router Introduction
From CoMakingSpace Wiki
This is the content required for an introduction to our Router - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)
Safety
Dangers
- exposed & rapidly spinning router bit
- no prevention of turning on after loss & restoration of power (keine Anlaufsicherung)
Precautions
- wear personal protection but not gloves, they could get caught!
- stay clear of the drilling bit when in operation
- unplug the router when changing a bit or touching the router for any other reason
- be prepared for sudden movements of the workpiece and make sure it is properly secured
- always check whether the tool movement you are planning is possible before turning it on - adjust depth and/or table if necessary
- make sure there is nobody nearby who might be surprised by a piece of shrapnel flying their way!
- if the power has been lost for whatever reason, make sure the router is turned off before restoring it!
Hints
- be cautions not to remove too much material at a time
Suggested Readings
For Tips and Tricks read the book "Woodworking with the Router" (available at the space). Tips for choosing the proper feed direction can be found on page 37ff.
