Project:Apartment Shoe Rack
From CoMakingSpace Wiki
| ProjectInfoBox Apartment Shoe Rack | |
|---|---|
| |
| Status: | done |
| Initiator: | Finno |
- Gallery
Design
"Hidden Hardware" used for the assembly of the Apartment Shoerack
Rough assembly after drilling all the holes for the hardware. Board edges are untreated
Press on edge banding being applied to raw edges of boards
Finished and in use shoe rack/ entryway table
Pictures; Design, creation and use.
If I were to do it again (and not have material to "upcycle") I would go to Hornbach with dimensions for the panels that are needed, and have them cut and edge band (Kanten-Umleimung) all of the pieces instead of using the press on stuff that I found. This is because, while the "raw wood" core of the board is hidden, the edges of the banding are quite sharp and if I sand them you would see the core of the sheet again.
