Project:Magnetic Knife Holder

The most important tool in the kitchen should be easily accessed, but knife blocks take up a lot of space and are not very hygienic. Personally I always fancied a magnetic holder, but the good looking ones are quite expensive.

ProjectInfoBox Magnetic Knife Holder
Status:	Done.
Release Date:	January 2018
Initiator:	Patrick
Materials Used:	wood, magnets, epoxy
Tools Used:	Cordless Drills, Chisels (Woodworking)
Approx. Cost:	around 10€

Materials

• some nice wood
  • I used some leftovers from our Common Room tables. which were already there right size
• Neodymium magnets
  • can be bought from eBay
• 5 min epoxy
• some sandpaper

Making

I sketched all the spots which should contain magnets on the piece of wood and drilled them out with a 7 mm wood drill (same size as magnets). The holes need to be a bit deeper than the thickness of the magnets, so they can pressed in slightly below the surface. Afterwards the magnets were pressed in and some 5 min epoxy was applied onto the magnets to secure them.

Once the epoxy has hardened the excess was removed with a Chisels (Woodworking) and sandpaper. I applied (coconut) oil onto the wood before mounting to protect it from moisture and bring out the grain of the wood.

Gallery

• 
  Marking the spots for the holes.
• 
  Drilling.
• 
  Inserting the magnets into the board. In some instances a hammer was needed.
• 
  Inserted magnets. Note they are slightly recessed from the surface.
• 
  Mixing the epoxy resin.
• 
  Applying epoxy onto magnets.
• 
  Done.