Project:Door Panel Storage Solution for VW T5: Difference between revisions
From CoMakingSpace Wiki
(Created page with "Project Description: Door Panel Storage for a Van This project involves designing and constructing custom storage compartments for the side and door panels of a van. The storage compartments are made from 4 mm beech plywood and are precisely cut using a laser cutter. The design process is carried out in Onshape, utilizing features like Laser Joint and Auto Layout for efficient and accurate CAD modeling. The assembly is achieved using finger joints (Laser Joint) for a st...") |
m (images added) |
||
| Line 1: | Line 1: | ||
'''Door Panel Storage for a Van''' | |||
This project involves designing and constructing custom storage compartments for the side and door panels of a van. The storage compartments are made from 4 mm beech plywood and are precisely cut using a laser cutter. The design process is carried out in Onshape, utilizing features like Laser Joint and Auto Layout for efficient and accurate CAD modeling. The assembly is achieved using finger joints (Laser Joint) for a sturdy and seamless fit. | This project involves designing and constructing custom storage compartments for the side and door panels of a van. The storage compartments are made from 4 mm beech plywood and are precisely cut using a laser cutter. The design process is carried out in Onshape, utilizing features like Laser Joint and Auto Layout for efficient and accurate CAD modeling. The assembly is achieved using finger joints (Laser Joint) for a sturdy and seamless fit. | ||
[[File:Onshape .png|thumb|Onshape CAD drawing using Laserjoint and Autolayout.]] | |||
[[File:Einzelteile.jpg|thumb|Sanding before assembly]] | |||
[[File:Assembly.jpg|thumb|Assembly using wood glue (PU glue might be better suited as it is less brittle to withstands vibration and fill cleaves)]] | |||
[[File:Rearview.jpg|thumb|Rear view of the panel]] | |||
[[File:Front view.jpg|thumb|Sidepanel and sliding door panel. A rubber gasket was applied for protection]] | |||
[[File:Sidepanel.jpg|thumb|For installation the original panels and holders were used]] | |||
Revision as of 17:36, 29 December 2024
Door Panel Storage for a Van
This project involves designing and constructing custom storage compartments for the side and door panels of a van. The storage compartments are made from 4 mm beech plywood and are precisely cut using a laser cutter. The design process is carried out in Onshape, utilizing features like Laser Joint and Auto Layout for efficient and accurate CAD modeling. The assembly is achieved using finger joints (Laser Joint) for a sturdy and seamless fit.
