Project:Apartment Shoe Rack: Difference between revisions
From CoMakingSpace Wiki
No edit summary |
(links & categories; minor typos) |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
<gallery heights=" | <gallery heights="250" mode="nolines" caption="Gallery"> | ||
File:PXL 20240103 180957255.jpg | File:SS Rack Plans.png|Design | ||
File:PXL 20240103 183445837.jpg | File:PXL 20240103 180957255.jpg|"Hidden Hardware" used for the assembly of the Apartment Shoerack | ||
File:PXL 20240104 145751030.jpg | File:PXL 20240103 183445837.jpg|Rough assembly after drilling all the holes for the hardware. Board edges are untreated | ||
File:PXL 20240229 165949283.jpg | File:PXL 20240104 145751030.jpg|Press on [[Edge Banding|edge banding]] being applied to raw edges of boards | ||
File:PXL 20240229 165949283.jpg|Finished and in use shoe rack/ entryway table | |||
</gallery> | </gallery> | ||
Pictures; | Pictures; | ||
Design, creation and use. | Design, creation and use. | ||
If | If I were to do it again (and not have material to "upcycle") I would go to Hornbach with dimensions for the panels that are needed, | ||
and have them cut and | and have them cut and [[Edge Banding|edge band]] ''(Kanten-Umleimung)'' all of the pieces instead of using the press on stuff that I found. | ||
This is because, while the "raw wood" core of the board is hidden, the edges of the banding are quite sharp and | This is because, while the "raw wood" core of the board is hidden, the edges of the banding are quite sharp and | ||
if | if I sand them you would see the core of the sheet again. | ||
[[Category:Furniture]] | |||
[[Category:Woodworking]] | |||
Latest revision as of 23:34, 29 July 2024
- Gallery
Design
"Hidden Hardware" used for the assembly of the Apartment Shoerack
Rough assembly after drilling all the holes for the hardware. Board edges are untreated
Press on edge banding being applied to raw edges of boards
Finished and in use shoe rack/ entryway table
Pictures; Design, creation and use.
If I were to do it again (and not have material to "upcycle") I would go to Hornbach with dimensions for the panels that are needed, and have them cut and edge band (Kanten-Umleimung) all of the pieces instead of using the press on stuff that I found. This is because, while the "raw wood" core of the board is hidden, the edges of the banding are quite sharp and if I sand them you would see the core of the sheet again.
