Laser Cutter Material Settings: Difference between revisions
(intro; Zing table & sample entries - will test/confirm tonight) |
(tested poplar plywood engraving - 100/100 works well!) |
||
| Line 33: | Line 33: | ||
| surface | | surface | ||
| NOT CONFIRMED YET | | NOT CONFIRMED YET | ||
|- | |||
! scope="row"| [[Poplar Plywood]] '''(untested example!)''' | |||
| 4 mm | |||
| engrave | |||
| 100 | |||
| 100 | |||
| surface | |||
| nice brown color | |||
|} | |} | ||
Revision as of 19:26, 30 November 2018
Unfortunately you can't just calculate the perfect settings based on the power ("Watts") of a laser cutter because the actually delivered energy is always based on a combination of power and speed, which is different for each brand or model of laser cutter. To make things more complicated, 100 % power in a cutting profile is not the same as 100 % power in an engraving profile...
As there is always some trial and error involved, please share your experience with the others! You can often use experience from other machines as a rough starting point.
In general, cutting is usually done at 100 % power and the highest speed that will still result in a reliable cut. If 100 % speed still gets you through (e.g. paper or cardboard), you should reduce the power until you find the sweet spot.
Once we have a permanent machine, we should also work on a github repository with VisiCut settings again.
Epilog Zing (30 W)
| Material | Thickness | Operation | Power | Speed | Focus | Comments |
|---|---|---|---|---|---|---|
| Poplar Plywood (untested example!) | 4 mm | cut | 100 | 30 | center (-2 mm) | NOT CONFIRMED YET |
| Poplar Plywood (untested example!) | 4 mm | mark | 15 | 100 | surface | NOT CONFIRMED YET |
| Poplar Plywood (untested example!) | 4 mm | engrave | 100 | 100 | surface | nice brown color |
