Project:Apartment Shoe Rack: Difference between revisions
From CoMakingSpace Wiki
mNo edit summary |
NitramLegov (talk | contribs) m Add Project Infobox |
||
| (7 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
[[File:PXL 20240103 180957255.jpg | {{ProjectInfoBox|project title=Apartment Shoe Rack|image=PXL_20240229_165949283.jpg|status=done|initiator=[[Finno]]}}<gallery heights="250" mode="nolines" caption="Gallery"> | ||
File:SS Rack Plans.png|Design | |||
File:PXL 20240103 180957255.jpg|"Hidden Hardware" used for the assembly of the Apartment Shoerack | |||
File:PXL 20240103 183445837.jpg|Rough assembly after drilling all the holes for the hardware. Board edges are untreated | |||
File:PXL 20240104 145751030.jpg|Press on [[Edge Banding|edge banding]] being applied to raw edges of boards | |||
File:PXL 20240229 165949283.jpg|Finished and in use shoe rack/ entryway table | |||
</gallery> | |||
Pictures; | Pictures; | ||
Design, creation and use. | Design, creation and use. | ||
If | If I were to do it again (and not have material to "upcycle") I would go to Hornbach with dimensions for the panels that are needed, | ||
and have them cut and | and have them cut and [[Edge Banding|edge band]] ''(Kanten-Umleimung)'' all of the pieces instead of using the press on stuff that I found. | ||
This is because, while the "raw wood" core of the board is hidden, the edges of the banding are quite sharp and | This is because, while the "raw wood" core of the board is hidden, the edges of the banding are quite sharp and | ||
if | if I sand them you would see the core of the sheet again. | ||
[[Category:Furniture]] | |||
[[Category:Woodworking]] | |||
Latest revision as of 23:10, 7 January 2025
| ProjectInfoBox Apartment Shoe Rack | |
|---|---|
| |
| Status: | done |
| Initiator: | Finno |
- Gallery
-
Design -
"Hidden Hardware" used for the assembly of the Apartment Shoerack -
Rough assembly after drilling all the holes for the hardware. Board edges are untreated -
Press on edge banding being applied to raw edges of boards -
Finished and in use shoe rack/ entryway table
Pictures; Design, creation and use.
If I were to do it again (and not have material to "upcycle") I would go to Hornbach with dimensions for the panels that are needed, and have them cut and edge band (Kanten-Umleimung) all of the pieces instead of using the press on stuff that I found. This is because, while the "raw wood" core of the board is hidden, the edges of the banding are quite sharp and if I sand them you would see the core of the sheet again.
