Project:Ultimate Frisbee Clips: Difference between revisions
From CoMakingSpace Wiki
(Disc Clip Project Page Start) |
No edit summary |
||
| Line 12: | Line 12: | ||
The only issuse I had was tha tthe hole for the keyring didnt fit the keyring I had. I printed it again scaled up to 110% and with the 0.4mm nozzle instead of the 0.8mm. | The only issuse I had was tha tthe hole for the keyring didnt fit the keyring I had. I printed it again scaled up to 110% and with the 0.4mm nozzle instead of the 0.8mm. | ||
The result was much better for what I wanted. | The result was much better for what I wanted. | ||
<gallery> | |||
File:PXL 20231003 091826173.jpg | |||
File:Small clip no clearance.jpg|No clearance | |||
File:Small clip view.jpg|Holding a disc | |||
File:Scaled clip better clearance.jpg|More clearance | |||
File:Scaled clip works.jpg | |||
</gallery> | |||
Revision as of 12:58, 1 November 2023
Someone on a team I used to play for had one of these clips to keep a disc on the outside of their bag when we were on a trip and I finally have the opportunity to print my own.
It is useful because it is very easy to 'warp' o bend a disc when you are (over)packing a bag to travel with.
I was lazy and didnt design my own clips. Instead I have used 2 different designs I found on thingiverse.
Design 1
Design 2
I ended up liking Design 1 more than Design 2. The only issuse I had was tha tthe hole for the keyring didnt fit the keyring I had. I printed it again scaled up to 110% and with the 0.4mm nozzle instead of the 0.8mm. The result was much better for what I wanted.
No clearance
Holding a disc
More clearance
