Project:ESC/POS Label Printing: Difference between revisions
From CoMakingSpace Wiki
(Create page) |
m (Remember that this is mediawiki and not typst) |
||
| Line 14: | Line 14: | ||
I am doing inventory and want to print labels. I found this thermoprinter in a pile of cables that I want to use for printing inventory labels. | I am doing inventory and want to print labels. I found this thermoprinter in a pile of cables that I want to use for printing inventory labels. | ||
= Hardware | == Hardware == | ||
My printer talks TTL that you can plug into the UART of a Raspberry Pi. | |||
= Software | I connected my printer's RX to a Raspberry Pi's TX and both printer and Pi to some power. | ||
There is a large amount of 57mm thermopaper available. You can even buy adhesive thermopaper which is ideal for this project. | |||
== Software == | |||
Revision as of 07:11, 15 September 2023
| ProjectInfoBox ESC/POS Label Printing | |
|---|---|
| |
| Status: | ongoing |
| Initiator: | Ada |
I am doing inventory and want to print labels. I found this thermoprinter in a pile of cables that I want to use for printing inventory labels.
Hardware
My printer talks TTL that you can plug into the UART of a Raspberry Pi.
I connected my printer's RX to a Raspberry Pi's TX and both printer and Pi to some power.
There is a large amount of 57mm thermopaper available. You can even buy adhesive thermopaper which is ideal for this project.
