Project:PC Desk Top: Difference between revisions
mNo edit summary |
No edit summary |
||
| Line 26: | Line 26: | ||
== Before == | == Before == | ||
The previous desk was the cheapest Ikea one with modifications around the | |||
The previous desk was the cheapest Ikea one with modifications around the screen: | |||
* holes drilled near the left corner for cables | |||
* power stripe zip-tied to the bottom left of the desk | |||
* a very janky shelf. The shelf's support is made by two legs going behind the screen, screwed to the top using L brackets. The shelf is only supported from the rear. | |||
Issues: | Issues: | ||
Revision as of 08:40, 15 October 2021
| ProjectInfoBox Desk top for a widescreen monitor | |
|---|---|
| |
| Status: | Done |
| Release Date: | 2021-10-10 |
| Initiator: | User:Ronanb |
| Materials Used: | Plywood, lumber, varnish, screws, glue, previous desk's legs and drawers |
| Tools Used: | hand saws, hand plane, cordless drill, clamps |
| Approx. Cost: | 70e |
Aim
A cheap desk that fits comfortably and solidly my setup.
Requirements
The big screen weights 12kg and the included foot cannot be used, the huge legs eat all the room on the des. A strong built-in screen support is needed.
There are more than 30 cables running between the PC, power strips and all the accessories: a sane(ish) cable management is critical.
The speakers should be at the desk level, as wide-spaced as possible, without obstructions
The desk surface needs some resistance to spilled liquids (except strong alcohols or thinners like white spirit or acetone)
Before
The previous desk was the cheapest Ikea one with modifications around the screen:
- holes drilled near the left corner for cables
- power stripe zip-tied to the bottom left of the desk
- a very janky shelf. The shelf's support is made by two legs going behind the screen, screwed to the top using L brackets. The shelf is only supported from the rear.
Issues: - the shelf had a big cutout made so that the webcam could fit (this was a test, to check if the cut-out was a big problem or not) - the shelf's support legs are screwed to the desk top which is of MDF+cardboard: any serious weight on the shelf will bring it down on the screen, which is not cheap nor easy to replace.
