Taps and Dies

From CoMakingSpace Wiki

The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
ToolInfoBox

Taps and Dies

Taps and dies.JPG
Synonyms: DE: Gewindeschneider
Material: metal, plastic
Location: metal workshop

Taps and dies are used to create or clean up threads, usually in metal.

Three-stage taps need to be used in the correct order (from rough to fine). You can tell the order by judging how complete the cutting edge is or by the rings around the shaft: 1 ring -> 2 rings -> no ring.

Here's a makezine tutorial on using taps and dies.


Taps

ToolInfoBox

Taps

M3 to M12 taps.jpg
Synonyms: DE: Gewindebohrer,
"Innengewindeschneider"
Type: bit
Material: metal, plastic
Location: metal workshop
Access Requirements: read this page

Taps can be ruined by incorrect use, please ask for help if you are new to them. Into anything harder than aluminum, they are driven by hand using a tap wrench (DE: Windeisen). For an easier start, try giving your hole a slight countersink.

Did you know? The proper drill bit size for common thread diameters can also be found on the back of most digital calipers!

We have a set of M3/4/5/6/8/10/12 three-stage taps with holders at least. We have a lot of larger taps that need documentation and a proper storage solution. Lmnl99 also brought in an M2 tap which only works with our holders when a piece of tape is wrapped around the shaft.

The rough M3 tap (one ring) was broken and is currently missing.


Dies

ToolInfoBox

Dies

M3 to M12 dies.jpg
Synonyms: DE: Schneideisen,
"Außengewindeschneider"
Material: metal, plastic, very hard wood
Location: metal workshop
Access Requirements: read this page

We have an assortment of dies of the following sizes and many more that need documentation/storage:

M3
M4
M5
M6
M8
M10
M12