Difference between revisions of "Router Table Introduction"

From CoMakingSpace Wiki
Jump to navigation Jump to search
(Added some demonstration points)
m (→‎Demonstration: little note that tightening only works through the top now)
Line 16: Line 16:
  
 
==Demonstration==
 
==Demonstration==
The Tutor will show you in detail how to
+
The tutor will show you in detail how to:
 
* Adjust and lock the height of the router
 
* Adjust and lock the height of the router
 
* Insert the bit into the router
 
* Insert the bit into the router
* Tighten the collet
+
* Tighten the collet through the top of the table
 
* Turn the router on and off by using the safety switch of the router table
 
* Turn the router on and off by using the safety switch of the router table
  
 
[[Category:Introductions]]
 
[[Category:Introductions]]

Revision as of 13:40, 1 August 2020

The handheld router introduction is required as a background for this introduction!

If you received that introduction before 2020-4-15, it still included the router table part and you only need to make sure you now watch both pages for updates. And as always: feel free to ask for a refresher whenever anything is not clear anymore!


When working on a router table, additional care needs to be taken as the router is turned upside down in a fixed position!

proper feed directions for safe push cuts - click to see an animation!
  • the workpiece can be grabbed and shot across the room if you attempt a climb cut, only do push cuts!
    • only feed from right to left when you work in front of the bit!
    • see schematic for other cases, but make sure you really understand what's going on
  • make sure the router table is screwed or clamped to a workbench before turning it on
  • keep all body parts at least a hand's width away from the exposed bit (use push blocks if that's not possible)
  • use all possible fences, guards, featherboards etc. to secure the workpiece and reduce exposure of the bit
  • make use of a starting pin (or similar) when working fenceless with a bearing bit tip #6

Demonstration

The tutor will show you in detail how to:

  • Adjust and lock the height of the router
  • Insert the bit into the router
  • Tighten the collet through the top of the table
  • Turn the router on and off by using the safety switch of the router table