Project:Music Station

From CoMakingSpace Wiki

Revision as of 16:14, 21 October 2018 by NitramLegov (talk | contribs) (added a gallery of building the box)

ProjectInfoBox

Music Station

MusicStation 06.jpg
Status: done
Release Date: August 2018
Initiator: Martin
Team: Martin
Materials Used: film faced plywood
Tools Used: Raspberry Pi
Software Used: Musicbox


Since existing bluetooth speakers do not provide enough power, Martin decided to build custom speakers for usage on the camping ground of different festivals.

Software

The system is based on a regular Rasbian Lite installation, which gets adjusted by the installation script in the following way:

  1. Installation and configuration of mopidy and useful extensions
  2. Installation and configuration of bt_speaker

Hardware

From an electronics perspective, the system uses a Raspberry Pi in combination with a X400 HAT. It gets powered by a couple of lead batteries.

The case is built with film faced plywood:


Further Improvements

Check possibility to use a ESP32

On the last Festival, I was mainly using the bluetooth functionality. Playback using Mopidy as well as the Wifi Hotspot was not really used. For bluetooth playback, a ESP32 should be enough. This should lower the needed power significantly.

Shutdown board in case of power losses

Since the system is powered by batteries, there is a possibility of sudden power outages due to a lack of remaining battery power. Therefore, there should be a circuit which either switches from one battery to another and then possibly sends a shutdown signal to the system.

Note: This is only needed for Raspberry Pi based systems.

Different speaker

So far the system is based on Visaton PX-10 speakers. Since they don't provide Thiele/Small parameters, I didn´t calculate the needed box volume and just made a 12 liter box for each speaker, which is most likely way too much.

The next version should use different speakers where the ideal box volume is known.

Make a workshop out of it

Once the new design is complete and tested, there could be a seminar in which we teach others to build their own bluetooth speaker.

Design a 3D-Printed front for the controls