Inclinometer: Difference between revisions
From CoMakingSpace Wiki
m ("digital protractor" fits much better for the goniometer (similar)) |
(use instead of winding sticks) |
||
| Line 2: | Line 2: | ||
|tool name=Inclinometer | |tool name=Inclinometer | ||
|image=inclinometer.JPG | |image=inclinometer.JPG | ||
|synonyms=level box, bevel box;<br>DE: Neigungsmesser, Neigungssensor,<br>digitale Wasserwaage | |synonyms=level box, bevel box, digital angle cube;<br>DE: Neigungsmesser, Neigungssensor,<br>digitale Wasserwaage | ||
|type=[[measuring]] tool | |type=[[measuring]] tool | ||
|material= | |material= | ||
| Line 23: | Line 23: | ||
[[File:drill press brain slug.JPG|thumb|200px|left|take the reference measurement on the chuck or drill bit, then move the table]] | [[File:drill press brain slug.JPG|thumb|200px|left|take the reference measurement on the chuck or drill bit, then move the table]] | ||
It's a bit trickier to get a good reference on the drill press as you'll have to reference the vertical chuck (or [[Drill Bit|drill bit]]) and the horizontal table is the moving part - but it pays out when you want to drill precisely! | It's a bit trickier to get a good reference on the drill press as you'll have to reference the vertical chuck (or [[Drill Bit|drill bit]]) and the horizontal table is the moving part - but it pays out when you want to drill precisely! | ||
<br clear=left> | |||
== Other Uses == | |||
* an inclinometer placed on top of a straightedge (like a sideways metal plane) can supposedly replace a pair of [[Winding Sticks|winding sticks]] - the straightedge is slid over the workpiece and you gradually remove material until you get a constant inclination reading<sup> [https://www.finewoodworking.com/2019/08/22/workshop-tip-use-a-digital-angle-cube-in-place-of-winding-sticks]</sup> | |||
[[Category:Marking & Measuring]] | [[Category:Marking & Measuring]] | ||
Revision as of 08:43, 16 January 2020
| ToolInfoBox Inclinometer | |
|---|---|
| |
| Synonyms: | level box, bevel box, digital angle cube; DE: Neigungsmesser, Neigungssensor, digitale Wasserwaage |
| Type: | measuring tool |
| Used with: | table saw, chop saw, drill press (bit more difficult) |
| Location: | wood workshop (next to marking & measuring shelf) |
| Access Requirements: | read this page & the manual |
| Manual: | in the box |
| Similar (More or Less): | squares, levels, goniometer |
A digital inclinometer with a magnetic base is an awesome helper for adjusting circular saw blades to a precise angle! Lukas is sharing this one on the marking & measuring shelf in the wood workshop.
Before you put the inclinometer back into its box, make sure to turn it off by holding the ON/OFF/REF button for a few seconds.
Table Saw or Chop Saw
To use, simply reference the saw's table as "zero", then let the tool snap to the side of the blade and adjust the vertical bevel until you're happy.
Drill Press
It's a bit trickier to get a good reference on the drill press as you'll have to reference the vertical chuck (or drill bit) and the horizontal table is the moving part - but it pays out when you want to drill precisely!
Other Uses
- an inclinometer placed on top of a straightedge (like a sideways metal plane) can supposedly replace a pair of winding sticks - the straightedge is slid over the workpiece and you gradually remove material until you get a constant inclination reading [1]
