Heat Gun: Difference between revisions

From CoMakingSpace Wiki

m (Category:Heat)
m (switching to a machine and add location and tutors as SMW parameters)
Line 1: Line 1:
{{ToolInfoBox
{{MachineInfoBox
|tool name=Steinel BHP 200/2
|machine name=Steinel BHP 200/2
|image=Steinel BHP 200-2.JPG
|image=Steinel BHP 200-2.JPG
|synonyms=hot air gun; DE: Heißluftgebläse,<br>"Heißluftfön"
|synonyms=hot air gun; DE: Heißluftgebläse,<br>"Heißluftfön"
|type=power tool
|type=power tool
|access=upon [[Hot Air Introduction|introduction]]
|access=[[Hot Air Introduction]]
|location=[[Metal Workshop|metal workshop]]
|location=[[Location::Metal Workshop|metal workshop]]
|material=[[Material:Heat Shrink Tubing|heat shrink tubing]], [[plastics]], [[metals]],<br>[[Epoxy Casting Resin|epoxy casting resin]] (to pop bubbles)
|material=[[Material:Heat Shrink Tubing|heat shrink tubing]], [[plastics]], [[metals]],<br>[[Epoxy Casting Resin|epoxy casting resin]] (to pop bubbles)
|tutors={{P}}, [[Lukas]]
|tutors=[[Tutor::User:Pakue|Patrick]], [[Tutor::User:Lukas|Lukas]]
|manual=in the case
|manual=in the case
|similar=[[Hot Air Soldering Station|hot air soldering station]]
|similar=[[Hot Air Soldering Station|hot air soldering station]]

Revision as of 20:35, 13 June 2019

MachineInfoBox

Steinel BHP 200/2

Steinel BHP 200-2.JPG
Synonyms: hot air gun; DE: Heißluftgebläse,
"Heißluftfön"
Type: power tool
Material: heat shrink tubing, plastics, metals,
epoxy casting resin (to pop bubbles)
Used with: spatulas, wire brushes
Location: metal workshop
Access Requirements: Heat Introduction
Manual: in the case
Tutors: Lukas
NitramLegov
Pakue
Johannes
Luzian
Keno
Similar (More or Less): hot air soldering station


A heat or hot air gun is useful to heat up metals that are hard to solder or to assemble 3D printer nozzles under heat, for example.

For well-regulated and more focused heat you may want to use a hot air soldering station instead.

Uses

scraping certain paints only works under heat
  • paint removal (see left)
  • bending 3D-prints (be careful, the line between bendable and liquid is very thin with PLA)
  • fitting heat shrink tubing
  • drying stuff (e.g. paint, but not recommended as it could cause cracks)
  • what else comes to mind?