User:Luzian/Foam Cutter

From CoMakingSpace Wiki

< User:Luzian

Revision as of 20:34, 13 June 2019 by NitramLegov (talk | contribs) (switching to a machine and add location and tutors as SMW parameters)

This is a wish list page - we don't have this tool yet!


MachineInfoBox

Foam Cutter

Machine-default.png
Synonyms: hot wire cutter; DE: Heißdrahtschneider
Type: power tool
Material: foam
Access Requirements:
Tutors:


A foam cutter uses a hot wire to slice through foam. It is perfect for any projects using foam (e.g. building model aircraft).

It's possible to build one out of thin metal tube, special wires and a handle with a button to control the power!

Use

Connect the power cable to a regulated power supply. Adjust the voltage to 3-6 V and limit the current to a maximum of 1.25 A (4 V/0.8 A works pretty well and increases the wire lifespan). Plug the power cable into the foam cutter and switch the power on. Now you are good to go. If you press the red button on the foam cutter the wire will heat up instantly.

Caution

  • don't touch the wire during operation
  • don't use more than 6 V
  • don't let children use the foam cutter without supervision

Wires

The foam cutter uses 70 mm StarTec ST 10659 wires. They are wear parts and can tear. New ones are available (for example) at ersa Distribution.